Cleaning without damaging the mold surface is achieved with the right chemicals, appropriate equipment, and controlled application. The aim is to clean dirt and residue without scratching or abrading the polished or coated surface of the mold.
How to clean without damaging the mold surface?
1. Selection of the right chemical
- Use neutral pH mold cleaners suitable for the surface
- Avoid abrasive acids and strong alkalis
- For coated molds, special "mold-safe" solvents should be preferred
2. Soft methods for mechanical cleaning
- Do not use wire brushes, sandpaper, or hard scrapers
- Prefer microfiber cloths or soft nylon brushes
- A plastic spatula can be used for carbon buildup
3. Appropriate application temperature
- The mold should be neither too hot nor too cold
- Cleaning at moderate temperatures increases chemical effectiveness and protects the surface
4. Correct application technique
- Chemical should be left on the surface for a short time, do not wait too long
- Compressed air should be used carefully (to prevent dirt from being pushed into internal areas)
- Apply in a thin layer
5. Post-cleaning protection
- After cleaning, a thin protective oil or silicone-based film should be applied
- The mold should be isolated from moisture and oxygen
6. Regular maintenance
- Periodic cleaning should be done before dirt accumulates
- The need for "hard cleaning" should be minimized
You can contact us for technical support regarding solutions suitable for your business.
